Grade 6 sculpted their Father's Day pots. Normally I wait until I have a completed sample to show you but with Father's Day approaching I thought I'd show you the process and add some pictures of the final results in a few weeks. That way if you want to try this with your class you still have time.
MATERIALS REQUIRED:
- clay
- access to a kiln or use air dry clay
- nails for cutting with
- wooden skewers
- little cups of water
- piece of canvas like fabric to work on
- rolling pin
- newspaper
- glaze
- potting soil
- cat grass seeds, alfalfa seeds, etc. for hair
PROCEDURE:
So the pot is made by slab construction. You can do a pinch pot but I wanted the Grade 6's to have a nice smooth surface to mold their face on.
Roll out a clay slab about 1/2 inch thick.
Cut a long rectangle with a nail.
Roll into a cylinder overlapping the ends a bit.
With your finger and a little bit of water smooth the seam and ensure a tight seal.
Cut a bottom out of remaining rolled clay. Trace around the outside of your cylinder.
Make a hole in the circle (bottom) for drainage in the finished pot.
To "glue" the cylinder to the bottom you want to scratch or score both pieces of clay where they will be attaching. Add a little bit of water with your finger.
Smooth the seam with your finger and a little more water if needed. Tap the pot on your work table lightly to ensure the bottom will be level.
Now we can start sculpting the face. We want this to look like our Dad so the students brought in photos or had them on their cellphones to use as reference. Start by molding the nose, attach a triangular shape to the pot and then round the tip and smooth the bridge of the nose.
Add the eyebrows. Roll out a thin snake.
Cut to desired length and attach smoothing into bridge of the nose. Make sure you scratch and moisten when "gluing" 2 pieces of clay together.
For the eyes you can form an outline using those thin snakes.
Apply to the face.
Cut little ovals out of some rolled clay for the eyeballs an attach inside the outline.
Using a skewer you can mark in the pupils.
Make a mouth in the same fashion with thin rolled snakes and apply to the face.
You can add scratches to the eyebrows as well as extra clay to form the cheekbones and chin. Just make sure to tap the pot after making the chin to ensure that flat bottom.
Add ears. You don't want them to stick out too far or else they will just break off.
Finally add a 1/2 piece of newspaper crumpled up and place in pot to help it hold it's shape while drying. Remove the newspaper before firing.
Place pots in a warm place with lots of air circulation to dry out. I cover mine loosely with garbage bags for about 2 days and then I remove the bags and let the pots finish drying. This slows down the drying process (we are so dry here in Calgary) and stops cracking.
That's it for now. I'll fire these pots in about 10 days or so when they are no longer cool to the touch. Stay tuned for part 2.
Later....
Pour some liquid tempera onto a plate. Using one hand dip into the paint.
Stamp on the petals around the circle you traced.
You should be able to get 5 or 6 handprints on.
Let the painting dry. Pop some popcorn.
Add about a tablespoon or so of dry tempera paint to the popcorn.
Put the lid on or hold a plate over top the container and give it a good shake. At school we have 4 large ice cream tubs with lids that we use every year.
When the painting has dried fill traced circle with glue and add popcorn until filled. Let the glue dry and then post on your bulletin board!
A popcorn garden. 
